RC модел U.S.C.G.C Acushnet - 13

First I make a cut of the material (unfolding). I cut out the sides and the ceiling, which is also a deck for the upper level (second floor). The good thing here is that when you are not sure of the final result, you can always make the fold out of cardboard and see the final result before you use up the material.

I solder the upper edge of the page to the ceiling, leaving the waterway sticking out, where there is one. But the lower end remains loose and bends a lot. In order not to bend, I solder additional strips (studs) from the inside 5-6 mm from the bottom to the top. On the ceiling, I also solder an additional transverse strip, but with the curvature of the deck (with beams).

In the four corners of the base I have soldered fasteners - a F2mm wheel spoke that protrudes down 1cm. They will fix the position of the superstructure on the deck.

And priming.