I clean the edge of the deck so that there is 3-4 mm from the edge at the end. It will form the burette after gluing the case. I cut a hole in the protruding part to access the hold (the inside of the ship) after gluing. The deck is ready for gluing. Now I clean up and fit the edge of the bottom to the deck. I drill the holes for the deadwood and rudder in the bottom. I glue the helm port to the bottom, right in the middle. I clean, fit and glue the bike stand and the model stand. I place the bottom on the model stand. I assemble the movement: The motor with the stand, with the frame and the deadwood and mount it in the middle of the model. Glued lightly with instant glue. If it is not as it should be, I glue it and repeat the procedure. I make sure that the movement is directly opposite the rudder and is the middle of the model. I stick firmly with Epoxy resin. I assemble and glue the stand of the servo machine. After the movement is firmly glued and the resin has hardened I assemble the rudder in the helm port with the tiller, the tillers, the servo, the servo mount in the middle of the model opposite the rudder. I glue the stand of the servo machine. I tape the deck to the bottom, making sure that the deck protrudes evenly from the bottom, I glue with Epoxy resin.